Networking with Wireless and LAN technology

Organizations Networking with Wireless and LAN technology

Example Case study:

In each branch there are 5 front office machines used for transaction processing and 5 back office machines used for various administration purposes. Wireless technology may be considered. However, the management is concerned about security. There is also an archive server and a real-time transaction server. The branches also have an internet connection for the webmail program used by the building society via a secure internet gateway. You must provide a template network schematic for branch LANs that incorporates connections to all of the above including the IP subnet and gateway ranges.


Organizations with many satellite offices typically hook up with one another with dedicated lines for potency and protection of sensitive knowledge in transit. For instance, several businesses use frame relay or Asynchronous Transfer Mode (ATM) lines as associate degree end-to-end networking answer to link one workplace with others. this will be an upscale proposition, particularly for little to medium sized businesses (SMBs) that wish to expand while not paying the high prices related to DDCs and Organizational intensities.

To address this want, Virtual personal Networks (VPNs) were developed. Following a similar useful principles as dedicated circuits, VPNs leave secured electronic communication between 2 parties (or networks), making a WAN from existing LANs. Where on earth it fluctuates as of frame relay and ATM is in its carriage standard. VPNs conduct over informatics exploitation datagrams because of the transport layer, creating it a secure passage through the web to associate degree meant destination. Basically mostly free based VPN enactments integrate open joint place coding approaches to any mask knowledge in the transfer.

Some organizations use hardware VPN solutions to reinforce security, whereas others use code or protocol-based implementations. Many vendors offer hardware VPN solutions, like Cisco etc. but an unrestricted no-cost software grounded VPN answer for Linux is there namely FreeS/Wan that operates on an undistinguishable Internet Protocol Security (IPsec) implementation. These VPN solutions, regardless of whether or not they square measure hardware or code primarily based, act as specialized routers that exist between the informatics affiliations from one workplace to a different.

When a packet is transmitted from a consumer, it sends it through the VPN router or entry that adds an Authentication Header (AH) for routing and authentication. The information is then encrypted and, finally, embedded with an Encapsulating Security Payload (ESP). This latter constitutes the secret writing and handling directions.

The receiving VPN router strips the header info, decrypts the information, and routes it to its meant destination either a digital computer or alternative node on a network. Employing a network-to-network affiliation, the receiving node on the native network receives the packets already decrypted and prepared for the process. The encryption/decryption method in a very network-to-network VPN affiliation is clear to a neighborhood node.

With such a heightened level of security, an assailant should not solely intercept a packet, however, decode the packet further. Intruders who use a man-in-the-middle attack between a server and consumer should even have access to a minimum of one in all the non-public keys for authenticating sessions. As a result of they use many layers of authentication and encoding, VPNs are a secure and effective suggests that of connecting multiple remote nodes to act as a unified computer network.

Basically, an IPsec affiliation is divided into 2 segments. In the first stage, an IPsec end point or user node resets the reference to a remote workstation or LAN/WAN. The remote workstation or LAN/WAN draughts the requesting nodule’s authorizations and every party botch out the verification approach for the connection.

IPsec affiliation uses the pre-shared key methodology of IPsec node authentication. In a very pre-shared key IPsec affiliation, each host should use identical key so as to maneuver to section a pair of the IPsec affiliation.

Phase a pair of the IPsec affiliation is wherever the safety Association (SA) is made between IPsec nodes. This section establishes An SA info with configuration info, like the encoding methodology, secret session key exchange parameters, and more. This section manages the particular IPsec affiliation between remote nodes and networks.

The Red Hat Enterprise UNIX system implementation of IPsec uses Ike for sharing keys between hosts across the web. The raccoon keying daemon handles the Ike key distribution and exchange.

The infrastructure which will be required here could be a very straightforward LAN which can change communication within the organization further as sharing of resources. The association to the outside/public are going to be through the web. The association to property right will be through a router from AN ISP or through an electronic equipment.

Below figure is a sample network plan that incorporates & implements simple IP-based telephony & communications using a wireless LAN utilizing existing BCSs & MSCs and PTSN PSTN channels that make up a secured channel to flow info from. VPNs & IPsec already implemented on both ends would also resolve the issue of security. This is not the final operation that can be performed some other network plans might be better but this is quite secure & cost effective technique with no extensive external hardware needed.

ISP-Wireless technology


Each branch has an archive server to record transactions made during the day (for auditing purposes). At the end of business hours, this information (up to 10 Gigabytes) is transferred to the Cyncoed office via a dedicated 2Gbps connection provided by a local ISP. There have been some concerns that the use of a dedicated line with 64bit point to point encryption may not be adequate. You must comment upon the suitability of this connection considering the data that passes through it and if necessary suggest an alternative.


Tunnel mode encrypts the complete original frame whereas adding a replacement header and a replacement verification. Sender severally destination area unit the 2 encryptions on both sides of the tunnel. The recently created frame could be a normal LAN frame that carries the initial frame as payload. The tunneling generates AN overhead of eighteen bytes, that ends up in a discount of the most output of sixty four computer memory unit frames to eightieth and will increase the latency by a few of microseconds thanks to the extra process needed by the method. The impact on the network performance remains tiny.

Tunnel mode is furthermore attainable with restate and reliability shield that will upsurge the overhead by another 18-24 bytes.


  • Original frame is totally encrypted
  • may be switched
  • Transparent to VLAN and MPLS
  • doesn’t need dedicated line
  • Compatible with Managed LAN Services


  • coding overhead of up to four-hundredth on frame level (with 64 byte frames)
  • will increase process needs

Both PPTP associated L2TP/IPSec use surgical operation to supply an initial envelope for the information, so append extra headers for transport through the internetwork. However, there square measure the subsequent differences:

With PPTP, encryption begins once the ppp association process therefore the ppp authentication is completed. With L2TP/IPSec, encryption begins before the surgery} association process by negotiating associate IPSec security association.

PPTP connections use MPPE, a stream cipher that’s supported the Rivest-Shamir-Aldeman (RSA) RC-4 coding algorithmic rule and uses forty, 56, or 128-bit coding keys. Stream ciphers encode knowledge as a trifle stream. L2TP/IPSec connections use the information coding normal (DES), that may be a block cipher that uses either a 56-bit key for DES or three 56-bit keys for 3-DES. Block ciphers encode knowledge in separate blocks 64-bit blocks, within the case of DES.

PPTP connections need solely user-level authentication through a PPP-based authentication protocol. L2TP/IPSec connections need constant user-level authentication and, additionally, pc-level authentication victimization computer certificates.

So two tunneling approaches that can be used to achieve the desired communication & transfer between point-to-point networks are as: Voluntary tunneling happens once a digital computer or routing server uses tunneling shopper package to form a virtual affiliation to the target tunnel server. To accomplish this, the suitable tunneling protocol should be put in on the shopper laptop. For the protocols mentioned during this paper, voluntary tunnels need associate degree information science affiliation (either LAN or dial-up).

In a dial-up scenario, the shopper should establish a dial-up affiliation to the internetwork before the shopper will found out a tunnel. This can be the foremost common case. The most effective example of this can be the dial-up net user, United Nations agency should dial associate degree ISP and acquire an online affiliation before a tunnel over the web is created. For a LAN-attached laptop, the shopper already includes an affiliation to the internetwork which will give routing of encapsulated payloads to the chosen LAN tunnel server. This could be the case for a shopper on a company LAN that initiates a tunnel to achieve a personal or hidden subnet on it LAN.

It is a standard idea that VPN affiliations need a dial-up connection. They need solely information science property between the VPN shopper and VPN server. Some purchasers such as home computers use dial-up connections to the web to determine information science transport. This can be a preliminary step in preparation for making a tunnel and isn’t a part of the tunnel protocol itself.

A number of vendors that sell dial-up access servers have enforced the power to form a tunnel on behalf of a dial-up shopper. The laptop the pc or network device providing the tunnel for the shopper computer is diversely called a side Processor (FEP) in PPTP, associate degree L2TP Access Concentrator (LAC) in L2TP, or associate degree information science Security entry in IPSec. For the needs of this report, the term FEP is employed to explain this practicality, no matter the tunneling protocol. To hold out its performance, the FEP should have the suitable tunneling protocol put in and should be capable of building the tunnel once the shopper laptop connects.

This configuration is thought as mandatory tunneling as a result of the shopper is compelled to use the tunnel created by the FEP. Once the initial affiliation is formed, all network traffic to and from the shopper is mechanically sent through the tunnel. With mandatory tunneling, the shopper laptop makes one surgical process affiliation. Once a shopper dials into the NAS, a tunnel is formed and every one traffic is mechanically routed through the tunnel. Associate degree FEP is organized to tunnel all dial-up purchasers to a selected tunnel server. The FEP may additionally tunnel individual purchasers, supported the user name or destination.

Unlike the separate tunnels created for every voluntary shopper, a tunnel between the FEP and also the tunnel server is shared by multiple dial-up purchasers. Once a second shopper dials into the access server (FEP) to achieve a destination that a tunnel already exists, there’s no got to produce a replacement instance of the tunnel between the FEP and tunnel server. Instead, the info traffic for the new shopper is carried over the present tunnel. Since there is multiple purchases during a single tunnel, the tunnel isn’t terminated till the last user of the tunnel disconnects.

There is a unit of immense variations between the purposeful necessities for point-to-point mode and multipoint mode. The hardware necessities area unit drastically higher for multipoint mode because the quality of the code key management, key assignment, frame analysis, etc. grows exponentially. One in every of the larger problems is that the key system as point-to-point encoding uses a pairwise key system, whereas multipoint encoding profits from cluster key systems.

Layer two encoding in multipoint mode are going to be work in progress for a minimum of subsequent 2 years. Thus it’s knowing choose a multipoint resolution nowadays that has the mandatory hardware design and also the powerful elements that enable upgrading the practicality with a straightforward microcode update. It’d be too pricey to own to interchange the whole hardware. Using tunneling can prove to be great & effective.

Part 2

Leave a Reply

Back to top button